At the beginning of the work, it is necessary to assemble the frame of the shutter, which consists of a box and guides. They need to drill several holes in the places where the equipment will be attached to the wall. The distance of the hole from each other should be 500 mm, while the holes that are at the top and below should be, there is a 100 venue of the edge of the cut. Tire connection with the box, occurs using a special guide device. Then, the finished frame is applied to the installation site. Using the level, the correctness and symmetry of the opening is determined. Using pre -prepared mounts on the box and tire, you need to drill a hole for dowels, this is better to do this with a quality tool. Before the repair, do not forget the porcelain tile to be purchased on the site .
At the time of installation of the frame, it is necessary to make sure that the tights of the fasteners are made evenly correctly, as well as the position of the tires and the box. Then, you can connect the controls to the electrical device, which connects the engine, power supply and switch. At the end, it is necessary to connect the control mechanism and stoppers, while the role of stoppers is played by the end circuit breakers.
