In order to install a water pump you need: you will need:
– pipe
– a mechanism that protects against dry
– Fum tape
– Reception valve
– The valve is reverse
– The coupling
– tap.
If you want to know more about ABB differential machines, but don’t know where? We advise you to visit our site and we find out everything about differential automatic machines ABV.
The pump must be mounted with a radical source, that is, near the well. The room where you will be installed should be dry and warm. If suddenly there is high humidity in the room, then the box where the contacts are located will constantly get wet and this will lead to the breakdown of your unit. Also, fix the pump well with the legs to a reliably stable surface. Because, in time of work, vibration occurs and if your pump is not reliably fixed, it will simply begin to move.
Pipes are best connected plastic, because it is not recommended to launch the station through the rubber hose. In this case, the diameter of the pipes should be the same as the pipe. Connection of the station should occur through a separate socket with grounding with fuses, this will protect you from the closure and from the breakdown. Before starting the pump, adjust the water pressure. The pressure should be put on the minimum value, this will give the opportunity to the device, less often it will turn on, which will greatly extend the operation of your pump.
