Let’s start the layout of the bathrooms and the bathroom, also take into account the number of guests. The bathroom can be made combined with a bathroom or a separate. In addition to the fact that there is a main bathroom, sometimes they want to make additional. It is not advised to have a toilet near the kitchen, a good option is to do it near the bedroom or between the bedrooms. With a two -level house, the most acceptable option would be to make a bathroom on both floors.
Measure the bathroom to start before starting the purchase of plumbing devices, shower or bathroom.
After that, you need to decide on which materials you want to make the diveting pipes, where the valves, ventilation boxes and sewer risers will be located later.
You need not to forget about the lighting and fastening of the wiring. It is also important to note the minimum distances that need to be in the middle of the wall and equipment.
Start distributing plumbing.
The bath is usually placed tightly by one side to the wall. The best option would be to place it in the center if there is a place. Do pipe eyeliner under the floor. Any shower can be purchased, but for economical use of the area the best option is angular, with sliding doors.
Leave the place in front of the bathroom about 1.05 m. Bits and heated towel rails are best installed 50-70 cm from the bath.
Place the toilet, taking into account its size and size. Leave in front of him free space at least 60 cm. Usually the washbasin install 80 cm from the floor.
Use best for finishing waterproof materials. First, find out if it can withstand active elements of household chemicals and the effects of salts. The factor of whether it is easy to remove and wash it is very important.
It is best to use ceramic tiles, such as Keram Marazzi, which can be used on the floor and on the walls, for finishing a wet room. In larger rooms, you can also use marble stone, mosaic or wood (processed).
The material for the ceiling is chosen so that it can easily withstand steam and moisture. This material must necessarily have water resistance, as well as sound -absorbed, reflective, should not emit toxic substances, have fire resistance and be easy to use. In the case of installation in the bathroom tile or rack suspension ceilings, lighting devices and also ventilation grilles can be easily mounted in them.
Paul can be made from ceramic tiles. Provide the waterproofing of the floor of a wooden house in advance. First you need to make a cement screed with a reinforcing mesh, after which lay a roll waterproofing with a capture of 10 cm of walls around the perimeter. We also need a layer of solution, on which later put the floor tile. It should be thicker than wall and withstand heavy loads. It is better if the surface is rough or smooth. The best option would be to use anti -slip tiles.
It is best to divide the light in the bathroom into a common one, which illuminates the room completely and point. Mirror, for example, can be lit separately with the washbasin.
