Before starting work, it will be necessary to prepare the basis made of wooden lag. Their thickness should be approximately 3-4 cm. Lags are laid parallel to each other, along the entire working surface. Then they should be treated with an antiseptic in order to avoid the formation of fungus and mold, under the surface of the parquet. Then install the beacons that will control the evenness of the flooring. If we talk about the parquet board, then the Parquet board of Karelia is of high quality and durability. Therefore, many use this particular parquet board.
Next, you can proceed to the floorboards of the parquet shields. They must be located across the lag, this is necessary to reduce the load on them. Moreover, each shield should fit into three logs, one of which will be located exactly in the middle of the shield.
Before starting, it is necessary to lubricate the grooves of the shield with waterproof glue. If on the shields there are not only the grooves with which they are fastened with each other, but also the crests, then the latter should turn to the wall. To prevent the cracks between the parquet shields, they are knocked down with a light blow of the hammer, according to the bar pre -applied to its edge. Excess glue that appeared on the surface, you must immediately remove with a soft rag. To attach the shields to the lags, they are nailed with nails under the slope. But it is worth remembering that you can not hammer nails in the front side of the shield. It should be remembered about the spacers that are placed between the wall and the parquet shields.
