Before finishing the room with new tiles, of course, first you need to remove the old. This is done using a hammer and a chisel. Moreover, the old dried solution should also be removed. The wall should be flat. .
For high -quality tile laying, the wall marking should. For this, a water level is used. The styling itself does not begin from the lower row, but from the second from the floor of the row. . This is necessary for better adhesion. You can also apply a solution to the tile.
The tile at first is pressed slightly against the wall – due to the fact that it will have to be trimmed, and in the process of this it is necessary to make sure that the solution does not have time to grasp. .
Then crosses, plastic separators are inserted between the tiles. And then the second layer is laid out. The dividers are subsequently removed, and the holes from them are covered with a solution.
Most likely, the tile will have to be cut in the corners. Usually all whole elements are not included. To cut the tiles, use a “grinder” or a special tile cutter. If these tools are not, then you can try to cut with glass cutter and then break the cut in the place.
At the very end, the seams are grouted.
On our site you can order any bathroom restoration services, namely the restoration of bathtubs by acrylic, a bulk bath, restoration of baths with liquid acrylic, coating of bathtubs with acrylic, bathtub restoration, bathtub acrylic coating, and reducing a bath with acrylic.