AProject
  • Ideas for giving
  • Construction
  • Home Ideas
  • Repair
  • Design
  • Real estate
  • Finishing
ECOBuild – all about construction
  • Ideas for giving
  • Construction
  • Home Ideas
  • Repair
  • Design
  • Real estate
  • Finishing

Installation of the rack ceiling: what and how

  • November 23, 2017

In order for the surface of the ceiling to have aesthetic appearance, you need to choose a package of high -quality rails and observe a number of elementary installation rules. For this process, you will need to use roulette, drill, screwdriver, pliers, scissors, self -tapping screws, dowels, knife and level.

First, the suspension structure is attached to the surface. In the load -bearing frame, several holes for the anchors must be made, which are inserted into the thrust eye and fixed. This is an extremely important element. The suspended structure is called so because they are fixed on the suspensions. The level of the ceiling height in the room should be sufficient, because after installing the surface height will decrease by 4-7 cm.

If the room has a low ceiling, you can create an exception and perform work without suspension, but it will be much more difficult to do. Materials for this work are as affordable as the construction of construction on the Internet.

The next step is to determine the direction of the racks, and the rack structure itself is cut to the dimensions of the room. To do this, use the scissors for metal or ordinary scissors. The level of the length of the rails should be 3-5 cm less than the real ceiling size.

The supporting profile structure is located at one mark in the perpendicular direction of the rails. Thanks to the suspensions, stringers are attached to the ceiling. Using the level, check the horizontal direction of stringers. After which they regulate the height thanks to adjusting springs.

Installation of rails begins with the edges after eliminating the protective film from them. Then the panels take turns sniff on the stringers. It is worth remembering that several dents can easily be made on the panels.

Share
Tweet
Pin it
Share
Share
You May Also Like
View Post

Non-destructive ultrasonic testing method for structures

  • March 3, 2025
View Post

What you need to know about metal structure design

  • March 3, 2025
View Post

Welding of metal structures: rules and recommendations

  • March 3, 2025
View Post

DIY kitchen repair

  • January 24, 2025
View Post

In the village! To the cottages!

  • January 23, 2025
View Post

Advantages of dry floors from gypsum fiber sheets

  • January 23, 2025
View Post

Painting of window frames

  • January 22, 2025
View Post

Podium in the apartment

  • January 21, 2025
Featured Posts
  • Internal insulation
    • February 28, 2018
  • Suspended ceilings – the best choice!
    • May 4, 2017
  • Installation of air conditioners
    • December 11, 2017
  • Sliding and folding doors for your home
    • June 6, 2017
  • “Underwater stones” during construction and repair
    • May 5, 2017
Recent Posts
  • Decorative jointing: features, technology and rules
    • March 3, 2025
  • Features of repairing a crack in a floor screed
    • March 3, 2025
  • Selecting plaster for finishing ceilings and application techniques
    • March 3, 2025
ECOBuild – all about construction
  • © ECOBuild – ecobuildit.com, 2017-2024.

Input your search keywords and press Enter.