The sheet material that is sheathed with the walls is finished with a natural veneer or a multi -layer decorative surface layer with a pattern. If the panels are large, it is very important to plan the location of the joints on the wall, as well as the joints at the door and windows. The panels can be attached to the frame with screws, you can fasten the panels to the strips. For this, the bar must be installed vertically and horizontally, vertical strips will become a support for the edges of the panels. With an interval of 60 cm, planks are installed between them. By the way, if you urgently need to buy a car in Pyatigorsk, then you can consider all the cars on sale on the site – .
Planes around the perimeter of sockets and switches should fit tightly to the housings. In the strips you need to drill the guide holes and outline their position on the wall. Traffic jams are inserted into the drilled holes and the strips are mounted with screws. The trimmed panel is securely fixed, the cut line is applied to it, which passes on the outlet.
You may need to measure and cut the first panel according to the profile of the side wall. The panel is pressed against the strips and is nailed with nails to vertical and horizontal strips. The next panel is installed in the end and fixed.
To cut a hole for a socket and a switch, the panel is placed on a workbench and the desired outline is planned on it. Holes are drilled in each corner of the contour, a hacksaw is inserted into them and a marked shape is cut down along the contour.
